Escalib Mills en Kit

eSCAlIb MIllS KIT Assembling and dismantling... 6 e S C A l I b M I l l S Md S K I T : S I T e S P I R A l S TA I R ToWe R WI TH S I d e e X I T ( bolT e d Modu l e ) > 1 - The base must be oriented according to the height of the floor which needs to be accesed. Start the installation 8 cm away from the wall to facilitate pivoting of the guardrails at the access level. level the base. > 2 - Access inside the module is available for attaching the sling to the center ring, for putting the guardrails in closed position and putting the erection rails in horizontal position. > 3 - Fitting the module to the base. Assembly of the 4 uprights with M24 screws. Sling released. > 4 - Installing a new module. > 5 - erection guardrail rotated to vertical position and locked onto stair above. bolt the uprights together using M24 screws. Slings released. Repeat steps 2, 4 and 5 if needed while anchoring the escalib as the height is increased. REQUIREMENTS: > Fit new anchorages as new modules are added. > dismantle in the reverse order of assembly. Fixings: - Module and base: M24x35 grade 8.8 hex head screw + washer. - Barrier gate: M16x100 hex head bolt I NTERMEDIATE MODULES Example of an Escalib Mills with 3 modules ASTUCE Start bolting with the new module’s first step (corner A-d) and then continue clockwise. N.B.: Check that the ground on which the staircase escalib Mills is to be erected is able to withstand the load. N.B.: Comply with the general rules for handling and stability.