Escalib Mills en Kit

ESCALIB MILLS KIT Additional components ... E S C A L I B M I L L S MD S K I T : S I T E S P I R A L S TA I R TOWE R WI TH S I D E E X I T ( BOLT E D MODU L E ) 11 Example: An 8-module Escalib located in Paris is subject to a peak wind pressure qp of 54 daN/m², corresponding to a wind speed of 107 km/h. In configuration I, the Escalib is anchored every 3 modules. Each anchors must withstand the following stresses: - shearing : V = 300 daN, - pullout :T = 200 daN. > PLASTIC POCKET FOR INSPECTION REPORT Description Code Weight Pocket for report NC0410 0.3 Inspection report NC0427 - (A4 sheet) > Additional accessories: “No entry” is displayed until the inspection report has been completed and inserted into the plastic pocket. NB : The holes drilled in the foot plates are to be used to nail through to wooden blocks when it is necessary to spread the load on the ground.They must not be used to anchor the Escalib Mills. >WRENCH (optional) Description Code Weight Combination wrench 13 mm 013013-8 0.07 Combination wrench 18 mm 013018-7 0.16 Ed wrench 22/24 mm (2x) 013024-5 0.28 Escalib 36 mm wrench 013036-9 0.46 > Anchorage : This beam coupler can be positioned anywhere on the module uprights. > ESCALIB MILLS BEAM COUPLER Description Code Weight Escalib Mills beam coupler 013049-2 2.0 Maximum loads on Etanco Ravalco/P eyebolt (model 359 200) in C20/25 concrete: (T² +V ²) < 400 daN & tan -1 (V/T) < 60° See manufacturer’s specifications for anchors and eyebolts. Slip force: 515 daN SLS. (pin + eyebolt + 1/2 ledger). > COMPLETE TIE Dimensions Code Weight 0.40 m 023031-8 1.8 1.00 m 023032-6 4.0 > ANCHOR POINT CLEVIS 0,50M Désignation Code Poids Anchor point clevis 0,50m 023050-8 2,7  18 50 (wall plugs not provided). Downloadable from www.mills.fr